Residual Risks - Anova Rlt14Pto Aufbauanleitung Und Benutzerhandbuch

- Do not overload the machine. The job will be done better and safer within established
parameters.
- Only use the machine with the correct and properly fitted safety accessories. Do not
alter any element of the machine that could affect safety.
- Never attempt to cut logs that contain spikes, wire or other similar objects.
- The machine must be fixed to the ground with suitable fixing elements.
- Pre-cut logs and wood chips are dangerous in the work area; The operator may slip,
trip or fall. Always keep the work area clear.
- Never put your hands on or near moving parts when the machine is on. Stay a safe
distance from the log, dozer and wedge to avoid serious injury.
- Before starting to split logs, make sure the cutting wedge has been lubricated to allow
for trouble-free work.
- Do not modify any part of the machine.
- When not in use, store the machine in a dry, safe place, out of the reach of children,
pets and people who should not use the machine.
- Inspect the machine for possible faults.
o You must inspect safety systems to ensure proper operation before beginning
to use the machine.
o Check that all moving parts are in good condition, working properly and that
there are no jams. All parts must be correctly installed and comply with all
standards to ensure proper operation of the machine.
o Damaged parts and protectors must be replaced or repaired by a specialized
workshop.
o If the warnings printed on the machine are damaged or illegible, they must be
replaced immediately.

1.4. Residual risks

Important
Even if you comply with relevant product safety regulations, residual risks may exist given the
characteristics of the equipment and the work for which it is designed.
Residual risks can be minimized by following safety instructions.
- You will reduce the risk of personal injury and equipment damage by following these
instructions and using caution.
- Failure to follow these safety instructions may result in injury to the operator or damage
to property.
- Lack of care, incorrect use, or failure to follow safety regulations can cause injuries to
hands and fingers when the wedge is in motion.
- There is a risk of electrocution if you use non-approved electrical connections.
- There is a risk of hearing loss when working with the machine without protection for
long periods.
- Health hazard from splinters and cuts. It is mandatory to use personal protective
equipment, such as protective gloves.
- Danger of injury to fingers and hands when unauthorized guiding or positioning of
wood.
- Injuries from pieces of wood detached due to unauthorized holding or guiding.
Note: Even if you take preventive measures, there may be residual, non-obvious risks.
Warning
Risk of jamming. Pay special attention to your hands when using the product. The lower height
stop must be adjusted to ensure a safe distance between the splitting wedge and the table.
6
EN