Using The Burners - Whirlpool B 10TC/CS BNV F Installationanleitung Und Betriebsanleitung

Adjusting the flame level Adjusting the flame level Adjusting the flame level Adjusting the flame level Adjusting the flame level
The flame level is adjusted by pressing the control knob
and turning it anticlockwise to the following positions:
Black circle = off
full flame
small flame
The symbols near the knobs show the position of the relative
burner on the hob. The burners are fitted with automatic
ignition and thermocouple safety device, which automatically
cuts off the gas from the burner in a few seconds if the
flame accidentally goes out during operation.
To ignite a burner ignite a burner, proceed as follows: ignite a burner ignite a burner ignite a burner
• turn the relative knob counter-clockwise until the pointer is
on the high-flame symbol;
• press the knob down fully to activate the automatic gas
ignition ;
• keep the knob pressed down for about 10 seconds with
the flame lit to allow the safety thermocouple to be heated;
• release the knob, checking that the flame is stable. If it is
not, repeat the operation.
! Some models have a Double Flame burner. In this case, to
activate it, simply start by turning the knob so that it is aligned
with the symbol, then press it all the way in and hold it in
this position for approximately 6 seconds, until the automatic
device keeping the flame alight has heated up.
For minimum power, turn the knob towards the low flame
symbol. Intermediate positions are possible by putting the
knob anywhere between the high and the low flame symbol.
To turn off the burner, turn the knob clockwise to the off
position " " .
Important: Important: Important:
Important: Important:
• Do not activate the automatic ignition device for more than
15 consecutive seconds.
• Difficulty in ignition is sometimes due to air inside the gas
duct.
• If a burner flame accidentally goes out, the gas continues
to exit for a few moments before the safety device
activates. Turn the control knob to the off position and do
not attempt ignition again for at least 1 minute, thereby
letting the gas disperse, which could otherwise be a
danger.
• When the appliance is not in operation, check that the knobs
are in the off position " ". The main gas supply cut-off
cock should also be closed.

Using the burners

Using the burners Using the burners Using the burners Using the burners
To obtain maximum efficiency from the burners, it is
advisable to only use pans with a diameter suitable for the
burner being used, so that the flame does not extend beyond
the pan base (see following table).
When a liquid starts boiling, it is advisable to turn the flame
down just enough to keep the liquid simmering.
Instructions for use Instructions for use Instructions for use
Instructions for use Instructions for use
Burner
A.Auxiliary
B.Semi-rapid
C.Rapid
D. Triple ring
I.Double ring DC-DR (inner)
I.Double ring DC-DR (outer)
! Make sure the pans do not overlap the edges of the hob
while it is being used.
! If the racks are unstable, they have been positioned
incorrectly.
The "separate double flame" burner The "separate double flame" burner
The "separate double flame" burner The "separate double flame" burner The "separate double flame" burner
This burner consists of two concentric burners which can
operate either together or separately.
Use of the double flame on the maximum setting gives a
very high power which reduces cooking times with respect to
conventional burners.
Moreover the double flame crown provides a more uniform
distribution of heat on the bottom of the pan, when using
both burners on minimum.
Pots and pans of all sizes can be used. In the case of the
smaller pots and pans we recommend the use of only the
internal burner.
There is a separate control knob for each of the "separate
double flame" burners.
The knob marked by the symbol
burner;
The knob marked by the symbol
burner.
To turn on one of the rings, press the relative knob in all the
way and turn it anti-clockwise to the high setting
is fitted with an electronic igniter that automatically starts when
the knob is pressed in.
Since the burner is equipped with a safety device "F" Since the burner is equipped with a safety device "F", Since the burner is equipped with a safety device "F"
Since the burner is equipped with a safety device "F" Since the burner is equipped with a safety device "F"
after lighting the burner keep the knob pressed in for about 6
seconds to allow the device which keeps the flame lit
automatically to heat up.
To turn off a burner, To turn off a burner,
To turn off a burner, turn the knob clockwise until it stops (it To turn off a burner, To turn off a burner,
should be on the " " setting).
To obtain the best results with the cooktop, several
fundamental rules should be followed while cooking or
preparing food. Use cookware with a flat bottom to make
certain that the pot sets properly on the cooking area.
Note
Note When there is no electricity supply, the burners can be
lit with a match after turning the control knob to the flame
position.
To turn on one of the burners, place a lighted match or lighter
near the burner, press the knob all the way in and turn it anti-
clockwise to the "High" setting.
12 12 12
12 12
ø Pan Diameter (cm)
6 – 14
15 – 20
21 – 26
24 - 26
10 - 14
24 - 28
operates the external
operates the internal
. The burner