Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
THE APPLIANCE MUST BE EARTHED
The hobs are designed to work with alternating current at the
supply voltage and frequency indicated on the rating plate
(situated under the hob or at the end of the instruction booklet).
Make sure that the local supply voltage corresponds to the
voltage indicated on the rating plate.
Connecting the supply cable to the mains electricity
Connecting the supply cable to the mains electricity
Connecting the supply cable to the mains electricity
Connecting the supply cable to the mains electricity
Connecting the supply cable to the mains electricity
supply
supply
supply
supply
supply
For models supplied without a plug, fit a standard plug,
suitable for the load indicated on the rating plate, onto the
cable and connect to a suitable socket.
To connect directly to the mains supply, a double-pole switch
with a contact separation of at least 3 mm suitable for the
load and complying with current standards and regulations,
must be fitted between the appliance and the mains supply
outlet. The yellow-green earth wire must not be interrupted
by the switch. The supply cable must be in such a position
that no part of it can reach a temperature of 50 °C above
room temperature. For installation above a built-under oven,
the hob and the oven must be connected separately to the
electricity supply both for safety reasons and for easy removal
of the oven if necessary. Do not use adapters or shunts as
they could cause heating or burning.
Before connecting to the power supply, make sure that:
• the limiter valve and the domestic system can withstand
Table 1
BURNER
D. Triple Ring
C.Rapid
C . R a p i d ( fo r m o d e l B 2 0 R /C S
BNV...)
B. Semi-rapid
A. Auxiliary
I. Double flame DC DR (internal)
I. Double Flame DC DR (external)
Supply pressure
* At 15°C and 1013 mbar-dry gas
Propane G31
H.s. = 50,37 MJ/kg
Butane G30
H.s. = 49,47 MJ/kg
Methane G20
H.s. = 37,78 MJ/m
Electrical connection
Electrical connection
Electrical connection
Electrical connection
Electrical connection
Burners and nozzles specifications
Burners and nozzles specifications
Burners and nozzles specifications
Burners and nozzles specifications
Burners and nozzles specifications
Diameter
Thermal power
(mm)
kW (H.s.*)
Nomin. Reduc.
130
3.25
100
3.00
100
3.00
75
1.65
55
1.00
30
0.90
130
4.10
3
the load from the appliance (see rating plate
• the supply system is efficiently earthed according to
standards and laws in force;
• the socket or double-pole switch are easily accessible when
the appliance is installed.
Important: the wires in the mains lead are coloured in
Important:
Important:
Important:
Important:
accordance with the following code:
Green & Yellow
Blue
Brown
As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
Connect the Green & Yellow wire to terminal marked "E E E E E " or
or coloured Green or Green & Yellow. Connect the Brown
wire to the terminal marked "L L L L L " or coloured Red. Connect the
Blue wire to the terminal marked "N N N N N " or coloured Black.
FAILURE TO OBSERVE THE ACCIDENT-PREVENTION
REGULATIONS RELIEVES THE MANUFACTURER OF ALL
LIABILITY.
Replacing the cable
Replacing the cable
Replacing the cable
Replacing the cable
Replacing the cable
Use a rubber cable of the type H05RR-F (H05VV-F for mod.
not .../CS) with a suitable cross section 3 x 0.75 mm². The
yellow-green earth wire must be 2-3 cm longer than the other
wires.
Liquid gas
By-pass
Injector
1/100
1/100
(mm)
(mm)
1.30
57
91
0.70
40
86
0.70
40
82
0.40
30
64
0.40
30
50
0.40
30
44
1.30
57
70
Nominal
Minimum
Maximum
This appliance conforms with the following European
This appliance conforms with the following European
This appliance conforms with the following European
This appliance conforms with the following European
This appliance conforms with the following European
Economic Community directives:
Economic Community directives:
Economic Community directives:
Economic Community directives:
Economic Community directives:
-
2006/95/EEC
EEC of 12/12/06 (Low Voltage) and subsequent
EEC
EEC
EEC
modifications;
-
2004/108/EEC
EEC
EEC of 15/12/04 (Electromagnetic Compatibility)
EEC
EEC
and subsequent modifications;
-
2009/142/EEC
EEC
EEC of 30/11/09 (Gas) and subsequent
EEC
EEC
modifications;
-
93/68/EEC
EEC
EEC
EEC of 22/07/93 and subsequent modifications.
EEC
17
17
17
17
17
see rating plate
see rating plate
see rating plate
see rating plate);
- Earth
- Earth
- Earth
- Earth
- Earth
- Neutral
- Neutral
- Neutral
- Neutral
- Neutral
- Live
- Live
- Live
- Live
- Live
Natural gas
Flow *
Injector
g/h
1/100
G30
G31
(mm)
236
232
124
218
214
116
196
193
116
120
118
96
73
71
71
65
64
70
298
293
110
28-30
37
20
20
25
17
35
45
25
Flow*
l/h
G20
309
286
286
157
95
86
390
Werbung
Inhaltsverzeichnis
