Cleaning And Maintenance - Whirlpool B 10TC/CS BNV F Installationanleitung Und Betriebsanleitung

To ensure long life of the appliance, it is essential to carry
out a thorough general clean frequently, taking into account
that:
• The appliance should be disconnected from the mains The appliance should be disconnected from the mains The appliance should be disconnected from the mains The appliance should be disconnected from the mains The appliance should be disconnected from the mains
supply before starting cleaning operations supply before starting cleaning operations. supply before starting cleaning operations
supply before starting cleaning operations supply before starting cleaning operations
• Avoid cleaning appliance parts when they are still warm.
• The enamelled or chromed or glass parts must be washed
with warm water without using abrasive powders or corrosive
substances which could ruin them.
• The steel parts, especially in areas with the screen-printed
symbols, should not be cleaned with diluents or abrasive
detergents; preferably use just a soft cloth moistened with
warm water and liquid detergent for washing dishes (wipe
the cloth over the steel in the same direction as the satin-
finish).
Denatured alcohol may be used to remove stubborn dirt.
Stainless steel can be stained if it remains in contact with
agressive detergents (containing phosphorus) or water with
a high lime content. After washing the stainless steel parts
they should be rinsed and dried with a soft cloth
(washleather).

Cleaning and maintenance

Cleaning and maintenance Cleaning and maintenance Cleaning and maintenance Cleaning and maintenance
13 13
13 13 13
• After cleaning, some special treatments are available to
bring back the shine to steel and to prevent it from yellowing;
for this purpose, we recommend you use the specific
"special cream detergent for steel care" available from our
Assistance Centres.
• Avoid leaving acid liquids (vinegar, lemon juice, aggressive
detergents, etc.) on enamelled or painted parts.
• The removable parts of the burners should be washed
frequently with warm water and soap, making sure to remove
caked-on substance. Check that the gas outlet slits are
not clogged. Dry the burners carefully before using them
again.
• Frequently clean the end part of the automatic glow plugs
of the hob.
Greasing the taps Greasing the taps
Greasing the taps Greasing the taps Greasing the taps
As time passes, a tap may lock or become difficult to turn. In
this case it will be necessary to clean inside and replace the
grease.
This procedure must be performed by a technician This procedure must be performed by a technician This procedure must be performed by a technician This procedure must be performed by a technician This procedure must be performed by a technician
authorized by the manufacturer. authorized by the manufacturer. authorized by the manufacturer.
authorized by the manufacturer. authorized by the manufacturer.