Selve SE Pro 1/6-RC Originalbetriebsanleitung Seite 23

Contents
Dear Customer,
by purchasing a SELVE electronic motor you have decided in favour of a quality product
from the SELVE company. This instruction manual describes the installation and
operation of the motor. Make sure to read this handbook before initial operation of the
SELVE motor and adhere to the safety instructions.
After publication of the operating instructions, SELVE shall not be liable for any changes
to norms and standards! Subject to change without prior notice!
1. Safety instructions ............................................................................................. 20
2. Information about the motor features ............................................................. 24
2.1. Designated use ............................................................................................ 24
2.2. Properties .................................................................................................... 24
2.3. SELVE commeo/iveo radio ......................................................................... 25
3. Installation and electrical connection ............................................................. 26
3.1. Installation of the motor into a shaft ......................................................... 26
3.2. Supporting the motors ............................................................................... 27
3.3. Assembly and disassembly of the pluggable cable ................................. 28
3.4. Electric connection ..................................................................................... 28
4. Setting of the end positions ............................................................................. 29
4.1. Delivery status ............................................................................................. 29
4.2. Mechanic requirements ............................................................................. 29
4.3. Setup functions ........................................................................................... 29
5. Setting of the end positions with setting switch/switch ................................. 30
5.1. Electric connection of the setting switch ................................................. 30
5.2. Automatic setup-mode with setting switch/switch ................................. 31
6. commeo initial operation (by radio) ................................................................. 32
6.1. Selection of a receiver ................................................................................ 32
6.2. Programming/deleting transmitters .......................................................... 32
6.3. Automatic setup-mode by radio ................................................................ 33
7. Technical data .................................................................................................... 34
8. General declaration of conformity ................................................................... 35
9. Disposal .............................................................................................................. 35
10. Troubleshooting ................................................................................................. 36
11. SELVE Service Hotline ....................................................................................... 37
Further detailed information for the start-up of the drive can be found in the
original operating instruction SE Pro-RC at www.selve.de
23
EN
EN