Cleaning A Clogged Tip; Maintenance; Daily Maintenance; Lubricating The Upper Packings - Titan Model 0290033 Betriebsanleitung

Cleanup
5.3

Cleaning a Clogged Tip

1. Follow the "Pressure Relief Procedure" in the Operation
section of this manual.
the handle is facing the opposite of the spray direction and
the handle clicks in the reverse position.
3. Trigger the gun once so that the pressure can blow the clog
until the tip is free of clogging.
The flow from the spray tip is at very high pressure.
Contact with any body part may be dangerous. Do
not place finger on gun outlet. Do not point the gun
at any person. Never operate the spray gun without
the proper tip guard.
6.

Maintenance

Before proceeding, follow the Pressure Relief
Procedure outlined previously in this manual.
Additionally, follow all other warnings to reduce the
risk of an injection injury, injury from moving parts
or electric shock. Always unplug the sprayer before
servicing!
6.1

Daily Maintenance

Two daily procedures are required for routine operator maintenance
on this sprayer:
B. Cleaning the filter screen
A) Lubricating the Upper Packings
1. Clean out the paint that has seeped past the upper packings
into the packing oil reservoir (fig. 13, item 1) above the fluid
section.
480) supplied by the factory. This will extend packing life.
PT6900
PowrTwin Plus DI
1
PT12000
GB
Do not over-fill the reservoir so that it overflows and
i
drips into the paint.
B1) Cleaning the Filter Screen (PT6900 Plus DI)
1. The filter screen will clog and must be cleaned at least once a
day.
2. Remove the retaining ring (Fig. 14, item 1) from the foot valve
housing (2).
3. Remove the inlet screen (3) from the foot valve housing (2).
4. Clean thoroughly with the appropriate solvent.
B2) Cleaning the Filter Screen (PT12000 Plus DI)
1. The filter screen will clog and must be cleaned at least once a
day.
siphon tube (2).
3. Clean thoroughly with the appropriate solvent.
13
Maintenance
2
3
1
2
1