Pressure Relief Procedure; Cleanup; Special Cleanup Instructions For Use With Flammable Solvents; Cleaning The Sprayer - Titan Model 0290033 Betriebsanleitung

Operation
4.6

Pressure Relief Procedure

Be sure to follow the Pressure Relief Procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray nozzles, or preparing for

cleanup.

locked position.
2. Turn off the sprayer.
a. To turn off the gas engine,
knob fully counterclockwise,
b. To turn off the electric motor,
knob fully counterclockwise,
3. Close the hydraulic shut-off valve on the hydraulic pressure
hose.
unlocked position.
5. Hold the metal part of the gun firmly to the side of a metal
waste container to earth the gun and avoid a build up of static
electricity.
6. Trigger the gun to remove any pressure that may still be in the
hose.
position.
8. Place the bleed hose into the metal waste container.
9. Open the bleed valve by turning it fully counterclockwise.
5. Cleanup
The sprayer, hose, and gun should be cleaned
thoroughly after daily use. Failure to do so permits
material to build up, seriously affecting the
performance of the unit.
Attention
Always spray at minimum pressure with the gun
nozzle tip removed when using mineral spirits or
any other solvent to clean the sprayer, hose, or
gun. Static electricity buildup may result in a fire or
explosion in the presence of flammable vapors.
5.1 Special cleanup instructions for use with
flammable solvents
length from spray pump.
place it into an empty five gallon container, then flush solvents.
GB
5.2

Cleaning the sprayer

1. Follow the "Pressure Relief Procedure" found in the Operation
section of this manual, section 4.6.
2. Remove the gun tip and tip guard and clean with a brush
using the appropriate solvent.
3. Place the siphon tube into a container of the appropriate
solvent.
Use only compatible solvents when cleaning
out oil based enamels, lacquers, coal tar, and
epoxies. Check with the fluid manufacturer for the
recommended solvent.
Attention
4. Place the bleed hose into a metal waste container.
5. Set the pressure to minimum by turning the pressure control
knob (1) fully counterclockwise.
6. Open the hydraulic shut-off valve located on the hydraulic
pressure hose (2). The handle should be in line with the hose.
7. Open the bleed valve (3) by rotating the bleed valve handle
fully counterclockwise.
2
8. Start the engine or turn on the electric motor.
9. Allow the solvent to circulate through the sprayer and
flush the paint out of the bleed hose into the metal waste
container.
10. Turn off the sprayer.
11. Close the bleed valve by rotating the bleed valve handle fully
clockwise.
12. Start the engine or turn on the electric motor.
Earth the gun by holding it against the edge of the
metal container while flushing. Failure to do so may
lead to a static electric discharge, which may cause
a fire.
13. Trigger the gun into the metal waste container until the paint
is flushed out of the hose and solvent is coming out of the
gun.
14. Continue to trigger the spray gun into the waste container
until the solvent coming out of the gun is clean.
For long-term or cold weather storage, pump
i
mineral sprits through the entire system.
15. Follow the "Pressure Relief Procedure" found in the Operation
section of this manual.
16. Store the sprayer in a clean, dry area.
Do not store the sprayer under pressure.
Attention
12
Cleanup
3
1
PowrTwin Plus DI