Conrad Electronic 3205200 Bedienungsanleitung Seite 21

Never touch the device close to the fog output opening when it is in operation or shortly after operation is stopped.
This part of the device becomes extremely hot. There is risk of burning.
Always empty the tank before transporting the device or not using it for a longer period.
11.1 Manual operation
Push the button FUNC until the display shows out.
Set the desired amount of fog with the arrow buttons and confirm with the button ENTER.
– F001
11.2 Operation via a DMX Controller
Each DMX device in a DMX chain requires an assigned DMX channel to be clearly targeted by the controller.
Push the button FUNC until Addr is displayed and push the button ENTER.
Select the desired start address A001-A512 with the arrow buttons.
Press the ENTER button to confirm your selection.
The set DMX channel can be used to set the fog volume now.
– DMX value 000 > no fog output
– DMX value 255 > maximum fog output
11.3 Master-Slave mode
Push the button FUNC until SLNd is displayed and push the button ENTER.
Select the NASt with the arrow buttons to define the fog machine as master device (control via the integrated
controller).
Select SLAv with the arrow buttons to control the fog machine in slave mode (control via the controller of the
connected master device).
Confirm your selection again with ENTER.
Note:
– If the device is to be operated as a single device (stand alone), it must be defined as a master device.
– Only one device in a master-slave-chain must be defined as master device. All other devices must be defined
as slave devices.
Minimum fog amount F100 Maximum fog amount
21