Parkside Performance PPFS 1250 A1 Originalbetriebsanleitung Seite 34

Continuous operation (Fig. E)
End: Press and then release
the on/off switch
product goes off.
NOTE
The product features a safety function
u
to prevent it from an automatic restart in
case of a power outage while using the
product in continuous operation. If the mains
supply is interrupted or the mains plug
is disconnected from the socket-outlet by
accident, the product will not switch on, once
the mains supply is restored. In such case,
you need to press and release the on/off
switch before using the product again.
[ ]
˜ Selecting the stroke rate
(Fig. A)
Adjust the stroke rate via the stroke rate control
o
panel .
[ 6 ]
The selected stroke rate (level 1–6) is shown
o
on the display .
[ ]
Level 1: lowest stroke rate
–
Level 6: highest stroke rate
–
Increase the stroke rate: Press the stroke rate
o
control button
[
Decrease the stroke rate: Press the stroke rate
o
control button
[
You can change the stroke rate during
o
operation.
The product memorises the selected stroke rate.
o
Once you switch on the product, the previously
selected stroke rate is set.
˜ LED work light
This product is equipped with a LED work
o
light to illuminate the immediate working
[ ]
area to improve visibility in poorly illuminated
areas.
The LED work light
[
o
as long as the product is switched on.
The LED work light
[
o
10 seconds after you switch off the product.
32 GB/IE
. The
[ ]
[ ]
.
]
.
]
lights up automatically
]
goes out within
]
˜ Trial run
NOTE
Always carry out a no-load trial run
u
before starting work and after every saw
blade replacement. Switch the product off
immediately if the saw blade is not running
smoothly, if considerable vibration occurs or
if you hear abnormal noises.
˜ Suspension hook
(Fig. G)
You can suspend the product from a beam, a
o
bar or any other object with a width of up to
50 mm.
You can set the suspension hook
o
3 positions: 0°/90°/180°.
˜ Working instructions
CAUTION! RISK OF INJURY AND
m
DAMAGE TO PROPERTY!
Wear gloves when handling the saw blade.
u
In this way, you avoid injury from cuts.
Do not use any blunt or bent blades or
u
blades which are damaged in any other
way.
Before sawing the workpiece, check for
u
hidden foreign objects such as nails, screws.
These must be removed.
Always insert a suitable saw blade.
u
Secure the workpiece with the aid of
u
clamping devices on the workbench.
Apply only as much pressure as is required
u
for sawing. If there is excessive pressure, the
sawing blade may bend and break.
Switch the product off immediately if the
u
sawing blade jams.
Spread the saw cut out and pull the blade
out carefully.
Always stand to the side of the product when
u
working.
to
4 ] [