Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. CONNECTING DEVICES TO THE RECEIVER
Only use connection cables certified by the manufactu-
rer to connect the devices to be controlled to the receiver.
Do not connect any loose wires to the plug pins of the
receiver. Do not use plugs from other manufacturers.
Ensure that the connected devices are connected to the same
ground as the receiver.
Before connecting the cable, switch off the power supply to
avoid an electric shock, a malfunction or a fire.
Read the manual of the devices you connect to the receiver
Ensure that the power supply is connected to the receiver correctly.
Mixing up negative and positive inevitably leads to all outputs of the
receiver beeing under voltage as soon as the power supply is
switched on! Only use the receiver within the voltage range from 9 to
36 volt (DC). The load of the entire system may not exceed a
maximum total current of 10 amps.
Ensure additional fusing of the power supply!
WARNING
NOTE
and follow the safety instructions in them.
WARNING
EN
11
Werbung
