DNT WeatherScreen PRO Bedienungsanleitung Seite 63

5. Commissioning,
5.1. Sync devices
- First,as described above,insert two Mignon/ AA / LR6batteries with the correct polarity in the
batterycompartmentof the combisensor. T heredLEDonthe sensorlights upfor 4 s after inserting
batteries.
Equipall room climate sensorswith batteries,as describedin the previouschapter.
Followingthis, connectthe basestation into a 230 V main socket.
- Placethe two devicesata distanceof approx.3 m from each other,so that they can synchronize.
The base station automaticallyreceivesthe data from the combi sensorfor the first 3 minutes.
The first attempt to receivetakes up to 3 minutes.Do not press any buttons on the base station
during this time. This would interrupt the synchronizationprocess.If the data from the outdoor
sensor appears on the display, and the signal strength is shown on the reception symbol, the
synchronizationis complete.In addition,a messageaboutversion,frequencyand IDof the weather
station appearson the information display.
Information on reception, see also chapter 12
The distance between the combi sensor, radio climate sensors, and the base station may
not exceed 100 m.This appliesto a direct line of sight. Obstaclessuch as planting,buildings,walls
etc. reducethe range.Underno circumstancesmaylarge metal objects,metal walls etc. be located
between the sensor and the base station, as these can cause a total loss of reception.
Do not operate the base station in the immediate vicinity of computers, monitors, televisions, and
switching power supplies.Thesecan significantly interferewith reception.
- Weather data is received every 16 s.
- If receptionis not possibleseveral times in a row, this is indicated in the correspondingdisplay
field where „
5.2. Set-up/settings,
- Pres s thebuttonato getintothesetting mode. Thecorresponding buttons contain thefollowing
base functions:
SELECT/+,select the unit or increasethe highlightedvalue.
SELECT/—, select the unit or reducethe highlightedvalue.
Right arrow key: selection of the next digit on the right.
Left arrow key: selection of the next digit on the left.
Up arrow key: selectionof the nextoption upwards.
Device
' will be displayed. A new search for the sensors then takes place for 3 minutes.
main page
Set-up/Settings
63