Put the radio temperature/humidity
1. Master sensor (supplied sensor)
Openthe battery compartmenton the back of the device and insert to Mignon/AA/LR6batteries
with the correct polarity,accordingto the polarity marking in the battery compartment.
Note:
Useonly high-qualitybatteriesto ensuresafeoperation,especiallyin colderweather.Werecommend
using lithium batteries.
Under no circumstances may rechargeable batteries be used. These cannot guarantee
permanently stable operation.
2. Additional sensor (optional sensor DNT000005)
- Youcan integrate up to eight additionalsensorsin the system.
Open the battery compartment at the back of the device. There are four DIPswitches above the
battery compartment:
- Beforeinsertingthe batteries,usethese DIPswitchesto configurethe addressing(switches1 to 3)
and the unit of measurement setting for the temperature display (switch 4).
- Youwill find a setting table on the outside of the battery compartment cover. Use DIPswitches 1 to 3
to install a free address in the system. Assign an individual address to each eight possible sensors.
An address duplication leads to a false display.
- Also set the desired temperature unit.
sensors into operation
61