Silvercrest SESR 6 A1 Originalbetriebsanleitung Seite 33

1. Pull the attachment
motor shaft if applicable.
[ 9 ]
2. Select the desired attachment
depending on the sneaker material:
Attachment
Soft brush
head (2)
[ 6 ]
Hard brush
head (3)
[ 7 ]
Sponge brush
head (1)
[ 8 ]
3. Push the desired attachment
onto the motor shaft
place.
˜ Switching on/off
Switching on: Press the on/off
o
button .
2 ] [
Switching off: Press the on/off
o
button again.
[ 2 ]
˜ Using the product
(Fig. D, E)
m NOTICE! Risk of property damage!
Do not immerse the whole attachment
/ in the water. Only wet the
7 ] [ 8 ] [
attachment head.
/ / out of the
6 ] [ [ 7 ] [ 8 ]
/ /
6 ] [ [ 7 ] 8 ] [
Sneaker material
Mesh fabric
o
Canvas fabric
o
Rubber
o
Leather
o
PVC
o
/ /
[ 6 ] 7 ] [ 8 ] [
until it clicks into
[ 9 ]
6 ] [
Use the product with dry hands only.
Before using the product, check with the
sneaker manufacturer or sales point to
ensure the sneaker can be cleaned with the
product and/or water. Improper use may
result in damage to the sneaker.
Do not apply excessive pressure when
using the product. This could damage the
sneaker's surface.
The attachment
too much pressure is applied.
Regularly check the cleaning result during
use. If you notice damage to the sneaker
surface, switch off the product immediately.
INFO:
Do not apply the product on sensitive
o
surfaces and laces.
Use sneaker cleaning detergent if
o
necessary.
Never use the product with aggressive
o
cleaning detergent and/or hot water.
1. Wet the attachment
water.
2. Apply little sneaker cleaning detergent onto
/
the wet attachment
/ / stops rotating if
6 ] [ 7 ] [ [ 8 ]
/ / with cool
[ 6 ] 7 ] [ [ 8 ]
/ / .
6 ] [ [ 7 ] 8 ] [
GB/IE 31