Built-In Installation - Scholtes FP 655 BNV Installationsanleitung

Built-in Installation

Built in installation
For correct operation of the oven built into a kitchen unit or
other housing section, the latter must be suitable.
The characteristics of the housing section and instructions
for fitting in and assembling are given below (Fig. 1- 2).
Protection against contact with electrical parts, in
compliance with current regulations, must be ensured by
FIG.. 1
correct building-in of the appliance.
All parts which guarantee protection, even any covering
panel (for example if an appliance is located at the end or
beginning of the modular units), must be fixed in such a
way that it cannot be removed without tools. It should be
noted that heat-resistant glues (90°C) must be used to bond
FIG.. 2
together the layers of plastic material and veneered wood
in housing units for built-in appliances.
Unsuitable plastic materials or glues that are not heat-
resistant are the cause of warping and ungluing.
Fitting onto base unit
The housing section must have the dimensions shown in
the figures and be fitted with supports allowing efficient
circulation of cooling air (Fig.3).
Suitable air intakes (Fig. 4) should be provided for efficient
ventilation on the bottom front part and the top part of the
appliance: bottom inlet of at least 200 cm², top outlet of at
least 60 cm² for 60cm (90 cm² ovens for 90cm ovens).
Installation into tall housing unit
The housing section must have the dimensions shown in
the figures and be fitted with supports allowing efficient
circulation of cooling air (Fig.10), It is also essential that
the oven is fitted with a ventilation pipe as shown in fig. 5. If
min. 45 mm.
the housing unit reaches the ceiling, it is indispensable to
connect an adequate channel to the ventilation pipe to convey
air outdoors.
Fixing onto base or tall housing unit
Insert the appliance into the housing section; open the oven
FIG.. 3 FIG.. 4
door and fix the oven to the kitchen unit using the four self-
screwing screws provided (fig. 6).
A
FIG.. 6B
FIG.. 5 FIG.. 6A
7