Scheppach HWW1400 Originalbetriebsanleitung Seite 18

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws,
the manufacturer of the device does not assume
liability for damages to the product or damages
caused by the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized ser-
vice technicians,
• Installation and replacement of non-original
spare parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric reg-
ulations and VDE regulations 0100, DIN 57113
/ VDE0113.
We recommend:
Read through the complete text in the operating
instructions before installing and commissioning
the device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important in-
formation on how to operate the machine safely,
professionally and economically, how to avoid dan-
ger, costly repairs, reduce downtimes and how to
increase reliability and service life of the machine.
In addition to the safety regulations in the operat-
ing instructions, you have to meet the applicable
regulations that apply for the operation of the ma-
chine in your country. Keep the operating instruc-
tions package with the machine at all times and
store it in a plastic cover to protect it from dirt and
moisture.
Read the instruction manual each time before op-
erating the machine and carefully follow its infor-
mation.
18 | GB
The machine can only be operated by persons who were
instructed concerning the operation of the machine and
who are informed about the associated dangers.
The minimum age requirement must be complied with.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules for operating
woodworking machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description
1. Pressure connection
2. Transport handle
3. Tank
4. Bracket for screws
5. Water drain plug
6. Manometer
7. Suction connection
8. Screw-on pre-filter cap
9. Pre-filter
10. Valve cover
11. Valve
12. On/off switch
3. Scope of delivery
• Operating manual
• House water system
4. Intended use
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of mis-
use. The user / operator and not the manufacturer will
be liable for any damage or injuries of any kind caused
as a result of this. To use the equipment properly you
must also observe the safety information, the assembly
instructions and the operating instructions to be found
in this manual. All persons who use and service the
equipment have to be acquainted with this manual and
must be informed about the equipment's potential haz-
ards. It is also imperative to observe the accident pre-
vention regulations in force in your area. The same ap-
plies for the general rules of health and safety at work.
The manufacturer will not be liable for any changes
made to the equipment nor for any damage resulting
from such changes.
www.scheppach.com