Werbung
TECHNICAL DATA
TECHNISCHE DATEN
CARACTERISTIQUES
TECHNIQUES
DATOSTÉCNICOS
DATITECNICI
CARACTERÍSTICAS
TÉCNICAS
CONNECTORS
ANSCHLÜSSE
CONNECTEURS
CONECTORES
CONNETORI
CONECTORES
——
——NJDI0——
USB MOUSE 2
MOUSE 1
COMPUTER
MONITOR
COMPIN
LINEOUT
VIDEO IN
VIDEO ` S-VIDEO
DIGITAL
` 8 PIN MINIDIN
15 HIGH DENSITY DSUB
15 HIGH DENSITY DSUB
3.5 mm
!
3.5 mm
4 PIN MINIDIN
USB
FEMALE
FEMALE
FEMALE
JACK
I
JACK
FEMALE
1 vec
Mac ADB
Analog R IN
Analog R OUT
TIP: right
|
TIP: right
1 GND
2 - Data
PS/2 clock
Analog G IN
Analog G OUT
RING: left
|
RING: left
2 GND
3 Data
PS/2 data
Analog B IN
Analog B OUT
STEM: common
'
STEM: common
3 Luma
4 GND
RS232 TXD
AGND
Reserved
|
|
4 Common
Not used
AGND
AGND
i
|
RS 232 RXD
Analog R GND IN
Analog R GND OUT
3.5mm
PHONOIRCA
RS 232 CTS
Analog G GND IN
Analog G GND OUT
JACK
FEMALE
GND
are
H
TIP: right
STEM: composite
10 Sync GND IN
Sync GND OUT
RING: left
SHIELD: GND
11 AGND
Not used
STEM: common
12 DDC/SDA
DDC/SDA
13 HSyne IN
HSync OUT
14 VSync IN
VSync OUT
15 DDC/SCL
DDC/SCL
L Bid uii
This equipment complies with the limits for a Class
A computing device, pursuant to Subpart J of Part 15 of FCC rules. Only peripherals (computer input/output
devices, terminals, printers, etc.) certified to comply with the Class A limits may be attached to a computer that complies with Class A limits. When connecting to a
peripheral device, a shielded input/output cable is required to ensure compliance with FCC rules. The shielded cable that must be used is supplied with the
equipment. Operation with non-certified peripherals or non-shielded cables is likely to result in interference to radio and TV reception.
This equipment generates and uses radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio
and television reception. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of
Part 15 of the FCC rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
.
Reorient the receiving antenna.
.
Relocate the projector with respect to the receiver.
.
Plug the equipment to a different outlet so that equipment
and receiver are on different branch circuits.
H
Fasten cables using mounting screws to ensure adequate EMI control.
You may require the following booklet from the Federal Communications Commission (FCC): "How to identify and resolve radio and TV interference problems",
available from the U.S. Government Printing Office, Washington, DC 20402, Stock No. 004-000-00345-4.
Ultralight SV1+ / Ultralight LX1
19)
www.proxima.com
Werbung
