Transport; Appliance Setup - Beko Rbi 6306 Hcs Bedienungsanleitung

Transport

instructions
The device should be transported only in
upright position.
The packing as supplied must be intact during
transportation.
After a transport in the horizontal position, the
device may only be taken into operation 4
hours after being stood up vertically again.
The appliance must be protected
moisture and other atmospheric influences.
The manufacturer assumes no liability if safety
instructions are disregarded.
A Disposal
Make the device unusable immediately. Pull
out the mains plug and cut the power cable.
Remove or destroy snap or latch locks before
disposing of the device. In this manner you
prevent children from locking themselves in
and endangering their lives.
Appliance setup
• Do not operate your appliance in a room
where the temperature is likely to fall below
10 oc at night and/or especially in winter. At
lower temperatures the appliance may not
operate, resulting in a reduction in the storage
life of the food.
• The climate class rate of your appliance is
given on the rating label located inside the
appliance. It specifies the appropriate operating
ambient temperatures as explained below.
Climatic class Ambient
SN.
ST +18
...+180
SN-ST.
SN-T
against rain,
temperatures
oc to 32 oc
oc to 32 oc
oc to 38 oc
C to 43 oc
oc to 38 oc
C to 43 oc
Location
Only place the device in dry rooms which can
be aired.
Avoid direct sunlight or direct heat sources
such as a stove or a heater.
If this cannot be avoided, the following
minimum distances
Electric stoves:
Heater:
Cooling devices:
• Ensure sufficient air circulation for your
device.
• Make sure that sufficient room is provided
around the appliance
circulation.
• The device should
surface.
Electrical connections
A Warning
This appliance must be grounded.
• Check whether the power type and voltage
your region corresponds to the one stated on
the rating label inside the appliance.
• The electrical safety of the appliance is only
assured when the grounding system in the
house is installed
regulations.
• When placing the appliance, do not let the
power cable get stuck under it; otherwise
cable will be damaged.
• Ensure that the plug remains readily
accessible. Do not use a multiple adapter bar
or an extension cable.
• The electrical specifications of your appliance
is given on the rating label located inside the
appliance.
• Route power cable to allow easy connection
and disconnection
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.
• A contact separator should be used if the
power cable is not accessible. (for built-in
models)
2
should be maintained.
3,00 cm
3,00 cm
2,50 cm
to ensure free air
be located on a smooth
in accordance with
after installation.
the