Dreame L10s Pro Benutzerhandbuch Seite 11

Preparation Before Use
Remove the protective strips
Install the side brush
Note: Install the side brush until it clicks into place.
Set up the charging dock
Peel of the double-sided tape at the bottom of the charging dock, then place the dock on
the level ground against the wall and connect it to power outlet.
Note:
Keep the immediate area 1.5m in front of the charger and 0.5m to both sides of
•
the charging dock clear of objects.
To ensure you can connect to the robot with your phone well, make sure the
•
robot and charging dock are withing Wi-Fi range.
Do no place the charging dock in an area with direct sunlight or where other
•
objects might block the signal, as this may hinder the robot from returning to the
charging dock.
Please clean the floor area where the charging dock will be placed with a dry rag.
•
Use of the double-sided tape is based on your need.
•
11