Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Switching on/off
Switching
Action
on/off
On
Press the switch trigger
and hold it in place.
The LED work light
up.
Off
Release the switch
trigger
The LED work light
off.
NOTE: You can use the LED work light
even when the product is not in use. Set the
rotation direction switch
position. Switch the LED work light on/off
according to above description.
Cleaning and maintenance
Before cleaning or carrying out any
maintenance:
–
Set the rotation direction switch
to the middle position. This prevents
unintentional switching on.
–
Remove the USB cable
–
Remove the bit
[
]
holder
or any of the attachments
[
]
[
]
[
]
.
–
Disconnect the charger
socket-outlet.
Never allow fluids to get into the product.
The product must always be kept clean, dry
and free from oil or grease.
Remove debris from it after each use and
before storage.
42 GB/IE
[
7 ]
8 ]
[
lights
7 ]
[
.
[
8 ]
goes
[
8 ]
5 ]
[
to the middle
5 ]
[
[
]
.
[
]
, the magnetic bit
[
[
]
from the
Regular and proper cleaning will help
ensure safe use and prolong the life of the
product.
Clean the product with a dry cloth. Use a
soft brush for areas that are hard to reach.
In particular clean the air vents after every
use with a cloth and soft brush.
The vents must always be clear.
NOTE
Do not use chemical, alkaline, abrasive
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces.
Maintenance
Before and after each use: Check the
product and the following accessories for
wear and damage:
–
[
]
Magnetic bit holder
–
[
]
Screw bits
–
[
]
Torque attachment
–
[
]
Eccentric attachment
–
[
]
Angle attachment
–
[
]
Cutting attachment
If required, exchange the accessories for
new ones:
]
–
see "Changing bits and magnetic bit
holder"
–
see "Replacing the cutting blade"
Observe the technical requirements of the
accessories (see "Technical data").
Werbung
