Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Remove the dust container from the vacuum cleaner by pressing the fixing mechanism
inwards and pulling the dust housing off the device (Fig. 1).
2. Hold the dust container over a suitable dustbin and press the release clamp down as
shown (Fig. 2). The base of the dust container folds down and the dust is tipped out.
3. Wipe out stubborn residue with a soft cloth or brush.
4. Close the bottom of the dust container again: push it upwards until it audibly clicks into
place.
5. Push the dust container back into the recess provided on the vacuum cleaner until you
hear it click into place.
Abb. 1
Accesories:
Nozzle for joints, corners, radiators, drawers, etc. with fold-out brush;
Danger:
- To ensure consistently good suction power, the HEPA filter must be cleaned regularly or replaced
after some time.
- Do not use water or cleaning agents to clean the filter.
- Never operate the vacuum cleaner without a filter.
Cleaning the filter:
- Remove the dust container from the vacuum cleaner as described under "Dust disposal" (Fig. 1).
- Turn the cover of the dust container to open it and remove the HEPA filter (Fig. 2 + Fig. 3).
- First, remove the dust from the surface. To do this, put the filter in a plastic bag and tap it gently
so that the dust does not get into the room air. You can also do this work outside, without a plastic
bag.
- After the dust has settled, carefully remove the filter from the bag.
Abb. 2
release clamp
cleaning
16
Werbung
