Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- Attach the floor brush to the suction tube.
To adjust the length of the height-adjustable suction tube
to your height, press the suction tube release button and
pull out the lower end to the desired length.
- Instead of the floor brush, the crevice nozzle (10) can also be attached to the suction pipe.
Parking positions:
Tab in
guide
Cable:
1. Pull out the cable. Pay attention to the yellow or black Marking on the cable. The cable may be
pulled out as far as (!) the black marking.
2. To rewind the cable, press the cable winder . This can also be operated with your foot. Hold the
plug firmly with your hand to prevent the cable from flying around.
Turn on a device:
1. Press the power button to turn on the device.
2. If you want to turn the device off again, press the on/off button again.
3. Unplug the device when you have finished using it.
Dust disposal:
This cyclone vacuum cleaner works without a dust bag. The dust is sucked into the dust container
and the air that comes out is filtered through built-in filters (HEPA filters) and blown out.
Please note:
The device must never be used without a filter. This could damage the motor!
To ensure consistently good suction power, the dust container must be emptied regularly,
otherwise the air flow and cleaning performance will be reduced.
To store the vacuum cleaner in a space-saving manner, push the
telescopic rod together and guide the tab on the floor brush
into the guide on the back of the device.
Service
15
Werbung
