DeWalt D25899 Originalanweisung Seite 25

Switching On and Off (Fig. A)
Switching on: set the on/off switch
Switching off: set the on/off switch
Demolition, Chasing and Channelling (Fig. A)
1. Select the appropriate chisel and clean.
2. Insert the chisel and check whether it is properly locked.
3. Set the desired impact energy level.
4. Fit and adjust the side handle
firmly tightened.
5. Hold the tool at both handles (
tool now runs in continuous operation.
6. Always switch off the tool when work is finished and
before unplugging.
Various types of chisels are available as an option.
Only D WALT-recommended accessories should be used with
e
this product.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
This machine is not user-serviceable. Take the tool to an
authorised D WALT repair agent after approximately 100 hours
e
of use. If problems occur before this time, contact an authorised
D WALT repair agent.
e
Accessory Maintenance (Fig. G)
Accessory maintenance at the right time guarantees optimal
results in application and a long and efficient accessory life.
Grind the chisels on grinding discs. Refer to Fig. G for the
appropriate angles of the following chisels:
Spade-shaped chisel
10
Cold chisel
11
Pointed chisel
12
U-shaped chisel
13
Hollow chisel
14
Mortar chisel
15
Toothed chisel
16

WARNING: These chisels can be reground only a
limited number of times. If in doubt, contact your dealer
for recommendations.

WARNING: Ensure that the cutting edge does not show
discolouration caused by too much pressure. This may
impair the hardness of the accessory.
1 to position 1.
to position 0.
1
3 and make sure it is
2 , 3 ) and switch on. The
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Electrical shock and mechanical hazard.
Disconnect the electrical appliance from the power source
before cleaning.

WARNING: To ensure safe and efficient operation,
always keep the electrical appliance and the ventilation
slots clean.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Ventilation slots can be cleaned using a dry, soft non-metallic
brush and/or a suitable vacuum cleaner. Do not use water or
any cleaning solutions. Wear approved eye protection and an
approved dust mask.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
EngLIsh
WALT-recommended
e
23