Herunterladen Diese Seite drucken

Minolta MULTI-FUNCTION BACK Bedienungsanleitung Seite 14

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

10
SETTING DATA AND COMMANDS
Set data for imprinting and commands for
controlling the camera as follows:
1. Select the desired function and mode.
2. Press the [
) key. Six diamonds will
appear in the display; the far left diamond
will be blinking, indicating that the corre¬
sponding digit of the display is ready to be
set.
3. Press the [0-^9) key repeatedly until the
desired number appears.
4. Press the [
] key again to move to the
next digit to the right; then set it by
pressing the [0-^9] key. (If it is un¬
necessary to change a particular digit, press
the
(
)
key
repeatedly
until
the
diamond corresponding to the next digit
you want to change starts blinking.)
5. Repeat the above process until all six digits
are set as desired; then press the (
)
key once more (i.e., seventh time) to start
the clock or calendar, or to store data for
other FI modes and commands for FII
modes. On the seventh push of the (
)
key, the diamond display will revert to the
previously set number corresponding to the
film setting. If the (
] key is pressed
again, the setting cycle starts over.

Werbung

loading