Herunterladen Diese Seite drucken

Minolta MULTI-FUNCTION BACK Bedienungsanleitung Seite 12

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

8
DATA-fMPRINTING MODES (Function I)
The types of data that can be imprinted in
Function I are shown in the table on the next
page. To select one of the six data-imprinting
modes, first press the [
FI] key, then press
the [ MODE) key repeatedly until the desired
mode is displayed. The FI display cycle is;
TIME -> DATE I ^ DATE II ^ DATE III ->
NUMBER ^ COUNT ^ Film Setting
(♦'s only; no imprinting) ->TIME ^
If the data-imprint switch is set at "AUTO",
the displayed data will be imprinted whenever
the camera's shutter is released. When it is set at
"MAN.", data can be imprinted before, during,
or after exposure by pushing the manual-
imprint button. When no data imprinting is
desired, turn the switch off. (The display will
remain on, and FII modes will still operate
when the switch is off.)
Data is imprinted by LEDs as six figures (in
three pairs) in the lower right-hand corner of
the frame. The data may be difficult to read If
imprinted on a bright or red area of the picture.

Werbung

loading