6
DATA EXPOSURE (Film Setting)
The data-imprinting time must be set ac¬
cording to the film's sensitivity to LEDs. First
determine the correct film setting from the
table at right, then:
1. Press the (
FI] key.
2. Press the [ MODE ] key repeatedly until only
diamonds appear in the display.
3. Press the (
♦
] key repeatedly until the
display contains the desired number of dia¬
monds. If there are too many diamonds,
continue pressing u-'.til the cycle starts over.
4. Press the[ MODE ] key to return the display
to normal.
NOTES
• Data exposure will automatically be set at ♦ ♦
when batteries are installed.
• In film settings 5 and 6, wait until the red
imprint indicator goes out before you advance
the film. When using Motor Drive 1 or Auto
Winder G to advance the film, do not use a
shutter speed faster than indicated in the table
at right.
• When using films not listed in the table or
when boosting a film's speed, take test photo¬
graphs or contact the nearest Minolta service
facility to determine the correct film setting.
• Film settings can be varied in accordance with
personal preference. Choosing a lower setting
(i.e., fewer ♦'s) will shorten imprinting time;
higher settings will have a longer imprinting
time.
• As a reminder of the film setting for films
you often use, remove the appropriate stickers
from the enclosed sheet and place them in the
open spots next to the Instruction label inside
the control-panel cover.