Tesla RoboStar iQ400 Plus Bedienungsanleitung Seite 36

The vacuum
cleaner got
2
stuck during
cleaning.
The vacuum
cleaner
interrupts
3 cleaning and
returns to the
charging base
prematurely.
The vacuum
cleaner does not
4
start cleaning as
scheduled.
The remote
control does not
5
work (the range
is 5 meters)
BATTERY CARE
•
If you are going to transport the robotic vacuum cleaner or if you are not going to use it for a long
time, turn it off.
•
Recharge the battery to full capacity after three months of non-use.
•
If you are not using the robotic vacuum cleaner for a long time, switch it off and also disconnect
the charging station from the mains. Nevertheless, you should fully charge the vacuum cleaner
once every three months to prevent the battery from completely draining.
The vacuum cleaner got stuck in a
small space, wound loose objects such
as curtains, carpet etc. on the cleaning
brushes.
If the battery is low, the vacuum
cleaner will automatically switch to
return mode and return to the charging
base.
The operating time varies depending
on the floor surface, the complexity of
the room and the selected cleaning
mode.
The vacuum cleaner is switched off or
the battery is dead.
You have not saved the scheduled
cleaning in the vacuum cleaner's
memory.
The vacuum cleaner is blocked.
Weak batteries in the remote control.
The vacuum cleaner is not switched on
or the battery does not have enough
charge to start cleaning.
The infrared sensor of the remote
control is dirty or the infrared signal
sensor on the vacuum cleaner is dirty.
There is signal interference between
the remote control and the vacuum
cleaner.
cleaning with a fully charged
battery.
The vacuum cleaner
automatically tries to free itself,
if it is unable to do so, please
clear the obstacle yourself.
Normal state, let the vacuum
cleaner charge to full battery
capacity and start cleaning
again.
Normal condition, no need
to deal with it.
Turn on the vacuum cleaner and
charge the battery.
Re-enter the time and day into
the vacuum cleaner's memory on
and make sure that the vacuum
cleaner is really fully charged.
Switch off and clean
the vacuum cleaner.
Replace the batteries, paying
attention to the correct polarity
when inserting them.
Make sure the vacuum cleaner is
switched on
and recharge the vacuum cleaner
battery.
Clean the remote control
and the vacuum cleaner.
Avoid using near other infrared
devices.