Tesla RoboStar iQ400 Plus Bedienungsanleitung Seite 32

your smartphone.
•
Try connecting to another Wi-Fi router or Wi-Fi Hotspot in another smartphone to rule out an error
on the part of your Internet connection.
•
You have too many devices connected to your Wi-Fi router, or the ability to connect a new device
to it is blocked.
•
Reset your Wi-Fi router.
Note: Make sure the charging station is within range of a good quality and strong Wi-Fi signal so it can
connect to a Wi-Fi network while charging. The robotic vacuum cleaner also needs this Wi-Fi
connection during its charging so that it is properly oriented and available to start cleaning. A Wi-Fi
network operating at a frequency of 2.4 GHz and WPA1 or WPA2 security is supported.
ROBOTIC VACUUM CLEANER FIRMWARE UPDATE
The firmware of the robotic vacuum cleaner is continuously improved. If a new firmware version is
available, you will be offered the option to download the update in the application and install it on the
robot vacuum cleaner.
WATER WIPING
Place the robotic vacuum cleaner outside the charging station and press the "2" button to turn it off.
•
Unfold the plastic cap and pour water into the tank. Only add water to the tank after removing the
tank from the body of the robotic vacuum cleaner. A slight leakage of residual water may occur
when handling. In this case, immediately wipe the spilled area with a dry cloth.
•
Install the mop cloth on the mop. Lightly moisten the mop cloth with water for faster and
smoother wiping with water. If the mop cloth is dirty after cleaning, you can carefully wash it in
lukewarm water.
•
Carefully insert the tank with the mop cloth holder installed into the body of the robot vacuum
cleaner. Do not pour water on the robotic vacuum cleaner or its interior, the robotic vacuum
cleaner is not waterproof.
•
Three cleaning levels of water wiping can be set in the phone application.
•
Do not leave the robotic vacuum cleaner unnecessarily standing in a place without movement or
with water residues in the water tank.
•
Keep a sufficient amount of water in the water tank for wiping or rinsing the mop.
•
After cleaning, always empty the remaining water from the water tank, rinse it and dry the mop
cloth.
•
We recommend wiping the floor with clean lukewarm water, as the cleaner may cause foaming
and worsen the water dripping onto the mop cloth or cause streaks on the floor after it has dried.
•
To get the best result when wiping with water, we recommend using this function in one room and