Tesla RoboStar iQ400 Plus Bedienungsanleitung Seite 29

•
Direct sunlight can cause reduced sensitivity of the robot vacuum's infrared sensors, please avoid
direct sunlight.
•
Black furniture and surfaces may not be properly detected due to the physical nature of the
infrared sensors. Therefore, a slight impact may occur which will be attenuated by the front
bumper. The vacuum cleaner may not work properly on dark surfaces.
•
Make sure that a debris bag is installed in the charging station before starting the cleaning
operation.
CHARGING THE BATTERY
Ideal location of the charging station
There must be no obstacles within 1.5 meters in front of the front of the charging station, and within
0.5 meters on the sides. A mirror or other objects with a strong reflection cannot be placed in the area
of the charging base 15 cm above the ground. The base should not be exposed to direct sunlight. Make
sure the charging station is within range of a good, strong Wi-Fi signal so that the vacuum cleaner can
connect to the Wi-Fi network while charging.
•
Connect the charging station to an electrical outlet.
•
Place the robotic vacuum cleaner in the charging station so that the charging connectors lightly
touch the contacts on the charging station. The robot vacuum cleaner battery will automatically
start charging and the "1" button on the top panel of the robot vacuum cleaner will slowly flash.
When the battery is fully charged, this button will light up permanently.
FIRST START
SMART CLEANING
•
This is the most used cleaning method. The device uses dynamic gyroscopic navigation and thus
moves along a cleaning route that is optimized for the best cleaning of the floor.
•
Press the "2" button to "Start cleaning" on the robot vacuum or press the "1" or "2" button on the
remote control. When cleaning is started, the robot vacuum cleaner should always be in the
charging station.
•
To interrupt cleaning/stop the robot vacuum cleaner, press the "2" button on the robot vacuum
cleaner or press the "2" button on the remote control.
RANDOM CLEANING
•
Place the robotic vacuum cleaner next to the charging station and press the "5" "Change cleaning
mode" button on the remote control and select "Random cleaning" cleaning (symbol 1). The
robotic vacuum cleaner will clean the area in automatic mode until 20% of the battery capacity
remains.
SPOT CLEANING
Place the robotic vacuum cleaner near the dirty place and press the "5" button on the remote control
"Change cleaning mode" and select cleaning "Spot cleaning".
CLEANING ALONG THE WALL
Place the robotic vacuum cleaner near the charging station and press the "5" button on the remote