Tesla RoboStar iQ400 Plus Bedienungsanleitung Seite 34

HEPA FILTER - cleaning once a week
•
Do not clean the HEPA filter with your fingers or a brush, only with a stream of clean water (do not
use cleaning agents) or vacuum it with a conventional vacuum cleaner.
•
Let the HEPA filter dry thoroughly, never install a wet HEPA filter in the robotic vacuum cleaner.
•
Do not expose the primary filter and HEPA filter to direct sunlight.
•
Vacuuming with a dirty HEPA filter or without an inserted HEPA filter can damage the robotic
vacuum cleaner.
•
We recommend changing the HEPA filter every 6 months. If wear, damage or contamination is
detected, replace the HEPA filter sooner.
MAIN CENTRAL CLEANING BRUSH AND SIDE CLEANING BRUSHES - cleaning 1 time per week
Remove the main central cleaning brush by pressing both handles on the brush cover. Use the cleaning
tool to remove hair tangled in the main brush. Keep the center cleaning brush free of large amounts of
hair, dust, cotton, etc. Check both side cleaning brushes together with the air intake hole at least once a
week according to the intensity of dust and remove tangled hair and other dirt from them.
SENSORS, CHARGING CONTACTS AND CHARGING STATION
Connectors of the charging station: Disconnect the power supply and clean the contacts once a month
with a soft, dry cloth.
Front wheel: Use a flat screwdriver to insert under the rubber wheel and remove it with an upward
movement. After cleaning, put it back until you hear a click. Also clean the axle of the wheel.
Floor sensors: Once a week, clean the three sensors on the bottom of the robotic vacuum cleaner with
a soft, dry cloth. Check that the front bumper, under which the impact sensor is located, is not blocked.