hanseatic HWC31ECIA Gebrauchsanleitung Seite 41

Operation
(7) (8)
(7)
Switch on/off appliance
(8)
Switch light on/off
(9)
Select temperature zone
(top/bottom)
(10) Temperature indicator
Before getting started
– Read the "Safety" chapter from page EN-4.
– Set up and connect the appliance as de-
scribed in chapter "Start-up" from page
EN-18.
Key tones
Each time you press one of the keys num-
bered (7) to (9) and (11) to (13), you will hear
a beep. This tells you that the appliance has
registered your keypress.
Door alarm
If the door is not closed more than 1 minute,
it will sound beep for 10 seconds to remind. If
still not closed, it will beep again after 1 minute.
(9) (10)
(11)
(12)
(13)
Switching the appliance on
and off
Switching on for the first time
• If you have not already done so, insert the
Switching on
• Press and hold the
Operation
(11) (12)
Increase temperature
Reduce temperature
Change temperature unit between
C
F
Celsius and Fahrenheit.
mains plug into an easily accessible and
properly installed socket (220–240 V~ /
50 Hz).
The temperature indicator (10) will show
the current internal temperatures,
– left for the upper zone,
– right for the lower zone.
You will hear the compressor start to work,
and the appliance will begin cooling.
The appliance is switched on.
key (7) briefly.
A beep will sound.
The temperature indicator (10) will show
the current internal temperatures,
– left for the upper zone,
– right for the lower zone.
You will hear the compressor start to work,
and the appliance will begin cooling.
The appliance is switched on.
Page EN-11
(13)
C
F