Page EN-6
Safety
If the mains plug is no longer acces-
■
sible after connecting it, an all-pole
disconnecting device complying with
overvoltage category III must be con-
nected into the house wiring with a
contact gap of at least 3 mm; consult
a qualified professional if necessary
(see "Service" on page EN-27).
When installing the appliance, en-
■
sure that the mains cable does not
become pinched or damaged. Do
not kink the supply cord or lay it over
sharp edges.
Keep the supply cord away from na-
■
ked flames and hot surfaces.
Always pull on the mains plug and
■
not the mains cable.
Never touch the mains plug with wet
■
hands.
Never immerse the supply cord or
■
plug in water or any other liquids.
If the mains cable of the appliance is
■
damaged, it must be replaced by the
manufacturer, the customer service
department or a similarly qualified
person in order to prevent hazards.
Independent or improper repairs
■
made to the appliance may cause
damage to property and personal in-
jury; any liability and warranty claims
will be forfeited. Never try to repair a
defective or suspected defective ap-
pliance yourself.
Inspections and repairs to the appli-
■
ance may only be carried out by au-
thorised specialists. If in doubt, con-
tact our service department (see
page EN-27).
This appliance contains electrical and
■
mechanical parts which are essential
for protection against potential sourc-
es of danger. Only parts correspond-
ing to the original appliance specifi-
cations may be used for repairs.
In the event of a fault, as well as before
■
extensive cleaning, pull out the mains
plug or isolate/unscrew the fuse.
Do not put any objects in or through
■
the housing openings, and also make
sure that children cannot insert any
objects in them.
Do not remove the covers from the in-
■
terior lighting. Do not attempt to re-
place the interior lighting. If in doubt,
contact our service department (see
page EN-27).
Check the appliance regularly for
■
damage.
Fire hazard!
Improper handling of the appliance can
lead to fire and damage to property.
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
Do not locate multiple portable sock-
■
et outlets or portable power supplies
at the rear of the appliance.
Risks associated with using
refrigerants
WARNING
Risk of fire and explosion!
Your appliance"s refrigeration circuit
contains the environmentally friend-
ly, but flammable refrigerant R600a
(isobutane).
Do not use mechanical devices or
■
other means to accelerate the de-
frosting process, other than those
recommended by the manufacturer.