Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Technical
Specifications
Power Supply
CRI23A or CR2/3A (replaceable battery)
Product Lifespan
10 years
Sensor Type
Electrochemical
Safety Standard
EN 50291-1:2018
Operating Temperature
4.4-37.80cgo
10% 85% RH(nan-condensing)
Alarm
Loudness
85 dB at 3 m (1Oft) @3.2± 0.3 kHzpulsing alarm
Storage and Transport Conditions
-20 600C(-4 1400F),
Silence
Duration
About
9 minutes
Operating Frequency
868 MHz
1000K)
RH(nan-condensing)
34 •
Maximum
Number
of Interconnected
Units
Transmission Range
What
to
Do When
the
Alarm
Sounds
1.Cal emergency servicesas soon as possible.
2 mmediate y move outside and make surethat everyone inside the house hasevacuated the areaor hasaccessto fresh air,
Do not re enter the house until it has been aired out and your alarm remains under normal condition. If it is not possible to
move outside, stay closeto an open door/window until emergency service responders arrive.
3. After fol owing steps 1-2 above, if your alarm reactivates within a 24 hour period, repeat steps 1-2 and call a qualified
appliance technician to investigate sources OfCOfrom fuel-burning equipment and appliances,and inspect for proper
operation of this equipment
4. f prob ems are identified during this inspection, have the equipment serviced immediately. Note any combustion equipment
that has not been •nspected by the technician and consult the manufacturer's instructions, or contact the manufacturers
direct y for more information about CO safety and this equipment. Make surethat motor vehicles arenot, and have not been,
operating in an attached garage or adjacent to the residence.
24 wireless units (on y compatible with X SenseLink* wireless alarms)
Over 250 m (820 ft) in open air
• 35 •
Werbung
