Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTES
J. You can silence all interconnected units by pressing the Test/Si/ence button on one Ofthe units. If one unit is still
alarming, it is the initiating unit (the unit that detected danger); to silence all interlinked units, you must also press
the Test/Silence button on the initiating unit.
2. While interconnected, the initiating unit cannot be triggered again during the 9-minute silence duration. However,
all other interconnected units can be triggered again if they detect danger during the silence mode.
LCD Display
While detecting CO, the LCD will display different indicators to inform you of the alarm status, as shown below.
LCD Display
Mode
Powerin
On
LED Indicator
Audible
Alarm
Remarks
Runsthrough 8 CYC eS
1 quick beep.
Makesure the battery
(yel ow/green/red) in
insulating film is
removed
sequence
device
• 28 •
Standby Mode
Alarm
Mode
Unit that
detects
and initiates
an alarm.
All other
interconnected
units in the
and the
network.
is turned
on,
The LED indicator
flashes
green once every 60
seconds.
A COconcentration ranging
from 30 to 999 ppm has
CO
been present for a certain
time period. The blue
backlight is lit, and the LED
indicator
flashes
red 4 times
every 58 seconds,
The LED flashes
red and
green 3 times sequentially
every 4 seconds.
• 29 •
None.
None,
4 quick beeps
Dangerous
repeating every
CO concentration
is
5.8 seconds.
detected, and has
reached the alarm status,
Please refer to "What
to
Do When
the CO Alarm
Sounds'
_
3 long beeps
Dangerous smoke
concentration
is detected
seconds.
by the initiating unit in
the network.
Pleasefind the initiating
unit and take action.
Werbung
