Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Mount and lock the device onto the wal by aligning the two mounting slots on the back of the device with the screwson
the wal .
6 Test the device by pushing the test button to make sure that the device is functioning properly.
Installation
on a Table
The baseof the detector hastwo feet built into the design that allow it to stand freey on a flat surface.
Feet
NOTE: When placing on a shelf, please adhere to the recommended placement as described in "Where to Install. "
• 22 •
Alarm
Testing
Be sure to test your alarmswhen you turn them on for the first time, or if the group configuration has changed. n addition to
the weekly tests you shou d perform, it is recommended to test the alarm after returning from a ong trip or vacation.
f your X-SenseXCOI - M carbon monoxide alarm is interconnected to other X-SenseLink* wireless alarms,we recommend that
every individual alarm be tested during the weekly test.
Test a Single Alarm
Actio
• Press the Test/SiIence button.
•Or tap the Device Test button in the app (for
devices connected
to the base station).
•The alarm will emit 2 setsof four quick beeps
Indication
every 58 seconds.
•The LEDwill flash red during the audib e signal.
• The LCDwill display"
," "PAS," the peak CO
concentration recorded sincethe previous reset,
and final y "0."
Test All
Interconnected
Alarms
Hold down the Test/SiIence button.
•The initiating unit will beep continuous y with the
LEDflashing red.
• Other
interconnected
alarms
in the network
receive the signal after 5 seconds,then they wil
beep continuously with the LEDflashing red and
green successivey, Releasethe Test/SiIence button
• 23 •
will
Werbung
