Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Warmly Reminding and Daily Maintenance
6.2 Maintenance Projects
In the process of use, if there is no solution to the problem:
You can log in the official website of ARTILLERY (www.artillery3d.com) to find information on software and
1
hardware, contact information, equipment operation, equipment maintenance, etc.
Alternatively, please contact us according to the phone number and email provided at the end of the manual.
2
Machine Cleaning
Nozzle
Printing Platform
on the surface of the platform, and if so, clean the surface of the platform.
Motion Mechanism
Equipment Self-inspection
Replacement of different consumables: the nozzle is preheated to
Consumable Replacement
the target temperature of the current consumables - return the
material and replace it with the target consumables material,
preheat the nozzle to the higher of the two consumables, nozzle
temperature - feed for 30s, until the remaining consumable is fully
extruded, set the nozzle temperature to the current consumable
nozzle temperature, complete.
22
Maintenance Instructions
Clean up debris inside the machine to ensure that
machine movement is not affected.
When the nozzle is blocked, after preheating and pulling out
the consumables, increase the temperature of the nozzle,
and use the through needle to pinch the extruder from top
to bottom until the consumables are poked out.
Check whether the wire is normal. If it is not normal,
检查出丝是否正常，如不正常请排查是否堵头。
please check whether it is blocked.
Check the nozzle for residual material and if so, remove
with a tool after heating the nozzle.
Check whether there are residual consumables and glue
XYZ shafts and screw rod lubrication.
Vibration optimization.
Automatic leveling.
Replacement of the same type of
consumables: follow the normal return-feed process.
Every time before printing
After each one time
replacement of consumables
Every time before printing
Cumulative printing time of every 500 hours
Cumulative printing time of every 300 hours
Cumulative printing time of every 300 hours
Werbung
