AWG EVO Originalbetriebsanleitung Seite 25

AWG | Nozzles | Turbo nozzle EVO
FOREWORD
Applicable standards and regulations
The design and construction of the AWG turbo nozzles EVO‎ was carried
out in accordance with the relevant provisions laid down by these directives
and the harmonised standards:
>
DIN EN 15182-1:2019-11 | DIN EN 15182-2:2019-11
Portable equipment for projecting extinguishing agents supplied by fire
fighting pumps – Part 2: Combination branchpipes PN 16
Conversions and modifications
Unauthorised conversions or modifications to the turbo nozzles EVO ‎ a re
prohibited without written consent from the manufacturer.
AWG Fittings GmbH accepts no liability for damage caused by conversions
or modifications, improper handling by the customer or by third parties
commissioned by the customer, or caused by non-compliance with these
instructions.
Other relevant documents
Apart from this manual, no other applicable documents are required for
the safe handling of the AWG turbo nozzles EVO.
The data sheet for these devices can be downloaded for information
purposes from the Internet: www.awg-fittings.com
Copyright
This operating manual is valid for all AWG EVO series turbo nozzles.
© AWG Fittings GmbH
All rights to this document are reserved by AWG Fittings GmbH.
This document may not be copied or reproduced in whole or in part
without the written permission of AWG Fittings GmbH. The document is
intended for persons using the device described and must not be passed
on to third parties.
Subject to technical changes and errors.
These instructions and the other applicable documents are not subject to
any automatic change service. The latest version can be obtained from
the manufacturer.
25
Revision: 02 – 10. 08. 2024
.
M1129B10 | Rev. 02-08/24