Tesla RoboStar iQ700 Plus Bedienungsanleitung Seite 35

•
Vacuuming with a dirty HEPA filter or without an inserted HEPA filter can damage the robotic
vacuum cleaner.
•
We recommend replacing the HEPA filter every 6 months.
MAIN CENTRAL CLEANING BRUSH AND SIDE CLEANING BRUSH - cleaning 1 time per week
Remove the main central cleaning brush by pressing both handles on the brush cover. Use a cleaning
tool to remove hair tangled in the main brush. Keep the central cleaning brush free of large amounts of
hair, dust, cotton, etc. Check the side cleaning brush together with the air intake hole, depending on the
intensity of pollution, at least once a week, and remove tangled hair and other dirt from it.
Front travel wheel: Use a flat screwdriver to insert under the rubber wheel and remove it by moving it
upwards. After cleaning, put it back until you hear a click. Also clean the axle of the wheel.
Floor sensors: Once a week, clean the four sensors on the bottom of the robotic vacuum cleaner with a
soft, dry cloth. Check that the front bumper, under which the impact sensor is located, is not blocked.
Connectors of the dustbin station: Disconnect the power supply and clean the contacts once a month
with a soft, dry cloth. Regularly check the dust bag in the charging station. E.g. once a week, remove
the dust bag, check that it is not full (if necessary, replace it with a new bag) and reinstall it in the
charging station.
DUSTBIN STATION
regularly check that the dust bag is full. Filling depends on the amount of dirt, cleaned area and
frequency of cleaning.
TROUBLESHOOTING
Problem
After installing the application and
pairing the mobile phone with the
robotic vacuum cleaner, the vacuum
cleaner is "Not connected".
The robotic vacuum cleaner does not
start cleaning.
The robotic vacuum cleaner cannot
be charged.
Solution
Turn your Wi-Fi router on and off, remove your robot
vacuum in the app, and try to pair it again. We recommend
always being close to the Wi-Fi router during pairing.
•
The robotic vacuum cleaner has a low battery. Charge
the battery to full capacity before starting cleaning.
•
The battery is too hot. Use the robotic vacuum cleaner
in temperatures of 0 °C ~ 40 °C.
•
The charging station is not connected to the network.
Make sure the power cord is properly connected.
•
The charging electrodes have bad contact with the
robotic vacuum cleaner. Clean the electrodes on the