Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CHARGING STATION WITH SUCTION UNIT
BEFORE FIRST CLEANING
•
Attach the side cleaning brush.
•
Remove the two foam stops located on the side of the robotic vacuum cleaner's bumper and the
stickers from the charging station.
•
Remove all protective films and stickers from the vacuum cleaner and the charging station.
•
Charge the robot vacuum cleaner's battery.
•
Before starting cleaning, prepare the room so that there are no objects left on the floor that could
hinder the operation of the robotic vacuum cleaner (larger papers, cables, stickers, small objects,
inappropriately placed carpet etc.). Move chairs and other larger objects away so that the robotic
vacuum cleaner can easily reach hard-to-reach places. Also remove objects that can damage the
robotic vacuum cleaner.
•
Direct sunlight can cause reduced sensitivity of the robot vacuum cleaner's infrared sensors,
please avoid direct sunlight.
•
Black furniture and surfaces may not be properly detected due to the physical nature of infrared
sensors. A slight impact may therefore occur, which will be dampened by the front bumper. The
vacuum cleaner may not work properly on a dark surface.
•
Make sure a dust bag is installed in the charging station before starting cleaning.
BATTERY CHARGING
Ideal location of Charging/dumping station
There must be no obstacles within 1.5 meters in front of the front of the charging station, and within
0.5 meters on the sides. A mirror or other objects with a strong reflection cannot be placed in the area
of the charging station 15 cm above the ground. The charging station should not be exposed to direct
sunlight. Make sure that the charging station is within range of a high-quality and strong Wi-Fi signal
so that the vacuum cleaner can connect to the Wi-Fi network during charging.
•
Connect the charging station to an electrical outlet.
•
Place the robotic vacuum cleaner in the charging station so that the charging connectors lightly
touch the contacts on the charging station. The battery of the robotic vacuum cleaner will start
charging automatically and the illuminated edge of buttons "3" and "4" on the upper panel of the
robotic vacuum cleaner will slowly flash blue. When the battery is fully charged, it will light up
1 Dust bag
2 Power connection indicator
3 Charging connectors for the vacuum cleaner
4 Hole for emptying the dust container of the vacuum cleaner
5 Power cable
Werbung
