Tesla RoboStar iQ700 Plus Bedienungsanleitung Seite 32

WATER MOPPING
Place the robotic vacuum cleaner outside the charging station and press the "3" button to turn it off.
•
Take out the dust and water tank, unscrew the plastic cap and pour water into the tank. Only add
water to the reservoir after removing the reservoir from the body of the robotic vacuum cleaner. A
slight leakage of residual water may occur when handling the reservoir. In this case, immediately
wipe the spilled area with a dry cloth.
•
Install the mop cloth on the mop holder. Lightly moisten the mop cloth with water for faster and
smoother wiping with water. If the mop cloth is dirty after cleaning, you can carefully wash it in
lukewarm water.
•
Carefully insert the container with the mop cloth holder installed into the body of the robot
vacuum cleaner. Do not pour water on the robotic vacuum cleaner or its interior, the robotic
vacuum cleaner is not waterproof.
•
In the phone application, after pressing the "Water control" button, three levels of water wiping
cleaning can be set. By turning on the "Mop only" function, you start cleaning without vacuuming
(the button for adjusting the suction power will be unavailable).
•
Do not leave the robotic vacuum cleaner unnecessarily standing still or with water in the water
tank.
•
Keep a sufficient amount of water in the water tank for wiping or rinsing the mop.
•
After cleaning, always empty the remaining water from the water tank, rinse it and dry the mop
cloth.
•
We recommend mopping the floor with clean lukewarm water, the cleaning agent can cause
foaming and thus worsen the dripping of water on the mop cloth or cause streaks on the floor
after it dries.
•
To get the best result when wiping with water, we recommend using this function in one room and
then moving to another room.
•
For safety reasons, do not charge the battery with the water reservoir filled with water.
Only non-foaming floor cleaners can be added to the water tank, follow the manufacturer's
recommended dilution. Do not use concentrated cleaners, perfumes, stain removers or substances
containing alcohol and chemicals.
RETURN TO THE CHARGING STATION
The robotic vacuum cleaner will search for the charging station automatically after finishing cleaning,
when the charge level is low, or after pressing the "4" button on the robotic vacuum cleaner, or after
clicking the "Charge" button in the application. In standby mode, the robotic vacuum cleaner consumes
very little, so we recommend not turning off the power supply to the charging station.