Installation And Adjustment; Tools; Manner Of Delivery; Adjusting The Seat Height - Vermeiren V100 Gebrauchsanweisung

3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
The Vermeiren V100 has been designed to be adjust with a minimum of replacements parts.
There is no need for extra stock of spare parts.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
L
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L
WARNING:
Variation of allowed adjustments can still change the stability of your
wheelchair (tilt back or sideways).
3.1

Tools

To set up the wheelchair the following tools are needed.
Wrench set n° 7 to n° 22
Allen key set n° 3 to n° 8
Screwdriver n° 4 to n° 5
Screwdriver Phillips head
3.2

Manner of delivery

The Vermeiren V100 shall be delivered with:
1 frame with arm supports, rear and front wheels (seat height of 500 mm - 19.69 in.)
1 pair footrests
Tools
Manual
Accessories
3.3

Adjusting the seat height

The Vermeiren V100 is adjustable in 3 seat heights by changing the wheels position. At each
height there is a different setting of the front and rear wheels.
L
WARNING:
The top hole of the axle plate is not intended for mounting the rear
axle - This hole is for mounting the drum brake.
Seat height
470 mm (18.50 in.)
500 mm (19.69 in.)
(Standard)
530 mm (20.87 in.)
Change the seat height according the following steps:
Rear wheel
Hole 1 Both bushings above the castor stem housing
Hole 2 One bushings above, and one under the
castor stem housing
Hole 3 Both bushings under the castor stem housing
Table 2: Seat heights
1.
Remove the rear wheels (see § 2.13).
2. Screw the axle bushings of the rear wheels
from the axle plate.
3. Assemble the axle bushings in the right hole of
the axle plate, see Table 2.
4. Check if the axle bushings are fastened well.
Page 15
Front wheel
EN
V100
2011-01