Troubleshooting - BOMANN DT 349 Bedienungsanleitung

Cleaning the appliance including interior Cleaning the appliance including interior
Cleaning the appliance including interior Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
• Remove for that the appliance content and stor-
age at a cool location.
• Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting Defrosting Defrosting Defrosting
CAUTION CAUTION CAUTION: : : : CAUTION
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
fridge
The has an automatic defrosting system. Dur-
ing defrosting water drops drains off at the back of
the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate.
Make sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
To achieve better cooling and to save energy, defrost
freezer
the regularly as follows:
• To start the defrosting process turn the tempera-
ture control to the off state and disconnect the
appliance from the power supply.
• Remove the food items and keep covered at a
cool location.
• When the ice has melted, wipe the condensate
away and dry the appliance interior.
• Then you may restart the appliance by connecting
the plug and turning the temperature control.
Reverse the bulb Reverse the bulb
Reverse the bulb Reverse the bulb
Specification: 220- - - - 240 V Specification: 220 Specification: 220 Specification: 220 240 V 240 V 240 V~ ~ ~ ~ , max. 1
• Loosen the screw of the lamp cover and remove
the cover to the back.
• Replace the defective bulb.
• Reattach the lamp cover and tighten the screw.
• Reconnect the appliance and put into operation
again.

Troubleshooting

Troubleshooting
Troubleshooting Troubleshooting
Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist
Problem Problem Problem Problem Cause / Action Cause / Action Cause / Action Cause / Action
Appliance is - Insert the power plug correctly or check
not working the fuse.
or not - Check the temperature setting.
properly - Check the ambient temperature.
- Unblock the ventilation openings, install
the appliance freely.
Stored food - Check the temperature setting.
is too warm - Open the door only as long as neces-
sary.
- Check the location.
Loud noise - Check the appliance position.
during oper- - See the section "Operating noise".
ation
Water on the - Check the temperature setting.
appliance - Clean the water discharge channel /
bottom opening.
Interior light - Insert the power plug correctly or check
is not work- the fuse.
ing - See the section "Reverse the bulb".
NOTE: NOTE:
NOTE: NOTE:
If a problem still persists after following the steps
above, contact your trader or an authorized techni-
cian.
23
, max. 10 0 0 0 W W W W , max. 1 , max. 1