Hendi MasterPro 209202 Gebrauchsanweisung Seite 12

Faults
Fault Symptom
Appliance does Green switch light & orange
not do anything lamp do not light
Green switch light & orange
Appliance
lamp do not light
remains cold
Appliance
remains cold
Green switch light & orange
Appliance does
lamp light
not reach the set
temperature
/ Long frying time
/ too high
temperature
If after these controls, the malfunctioning continues, it is advisable to contact your supplier for
1) Reset overload circuit breaker
- Allow the deep fryer to cool down.
- Remove the detachable control panel from the support.
- Unscrew the black protective cap from the bottom of the detachable control panel.
Press the "reset button" of the overload circuit breaker. You should hear a clear click.
-
- Screw the black protective cap back on.
- Reinstall the detachable control panel on the support.
Warranty
Any defect affecting the functionality of the appliance that becomes apparent within one year after
purchase will be corrected by free repair or replacement provided the appliance has been used and
maintained in accordance with the instructions and has not been abused or misused in any way. Your
statutory rights are not affected. If the appliance is claimed under warranty, state where and when it
was bought and include proof of purchase (f.e. receipt).
In line with our policy of continuous product development we reserve the right to change the product,
packaging and documentation specifications without notice.
Discarding & Environment
At the end of the life of the appliance, please dispose of the appliance according to the regulations
and guidelines applicable at the time.
Throw packing materials like plastic and boxes in the appropriate containers.
Used frying oils and fat dispose according to legal regulations and guidelines.
In case of any doubt, always contact your supplier!
Possible cause
No mains voltage
Switch is off
Check if the thermostat
is on
Thermostat defective
Detachable control
panel is not correctly
positioned on the
support
Overload circuit
breaker tripped.
Micro switch defective Contact your supplier
Overload circuit
breaker defective
Thermostat defective
assistance.
Possible solution
Check the electrical
installation.
Turn on the switch
Switch defective
Turn on the thermostat
Contact your supplier
Install the detachable control
panel correct on the support.
See Installation.
Reset the overload circuit
breaker. See note 1)
Contact your supplier
Contact your supplier