Silvercrest SFSGM 1.5 B2 Kurzanleitung Seite 18

Setting up the device
• Place the device on a dry, level surface.
Operation
Do not reach into the device or touch hot or sharp parts.
Closing the foil packaging
The device is designed for a maximum operating time of
1 minute without interruption. After this, the device must re-
main switched off until it has cooled down to room tempera-
ture.
NOTE: please open the packaging such that straight opening
edges form. Otherwise straighten them with scissors before clos-
ing.
The device is suitable for re-closing an existing foil packaging or
plastic bag with a thickness of 0.05 – 0.2 mm (e.g. crisps or wine
gum bags).
1. Tilt the safety bracket 3 downwards.
2. Insert the upper end of a foil packaging into the end of the
device marked with the symbol
3. Carefully press the end marked with the symbol
gether and keep it pressed together until the welding areas
heat up after several seconds.
4. Figure B: hold the packaging in one hand. Pull the device
evenly from one edge of the packaging to the other and
weld them together.
Opening of a foil packaging
1. Insert the upper end of a foil packaging into the end of the
device marked with the symbol
2. Press the end marked with the symbol
16
GB
2.
7.
7 together.
2 to-