Technical Specifications; Warranty Terms And Conditions - Texas A/S Fusion 10TG Bedienungsanleitung

Technical specifications

Model
Engine
Engine rotations/min
Blade rotations/min
Working width
Working depth
Gear
Cultivating speeds
Weight
Vibration level
Left / right handle
Uncertainty
Sound pressure level L
pA
Measure uncertainty
Sound power level L
WA
Measure uncertainty
* Measured at the center of blade shaft.
Fusion 10TG / 10B
212 cc TG720 /
208 cc B&S Vanguard
3600 rpm (no-load)
40-100 rpm (no-load)*
35-62-68-90 cm
38 cm
3 (R-H-L)
8 forward and 4 reverse
90 / 92.5 kg
2
5,96 / 3,39 m/s (10TG)
2
3.36 / 4,01 m/s (10B)
2
1,5 m/s
86,1 / 81,3 dB(A)
3 dB
99 / 99 dB(A)
3 dB

Warranty terms and conditions

The warranty period is 2 years for private end users in
EU countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Restrictions and requirements
Normal wear and replacement of wearing parts are
NOT covered by the warranty.
Wearing parts, which are NOT covered for more than
12 months:
•
Blades
•
Cables
•
Belts
•
Switches
•
Membranes/gaskets
•
Spark plugs
•
Engine liquids (oil, gasoline)
•
Starter cords
•
Filters
If you start the engine without adding oil, it will be
damaged and cannot be repaired and therefore not
covered by the warranty.
The warranty does NOT cover damages/faults
caused by:
•
Lack of service and maintenance
•
Structural changes
•
Exposure to unusual external conditions
•
Damages to the bodywork, deck, handles, panels
etc.
•
If the machine has been improperly used or
overloaded
•
Wrong use of oil, gasoline or other liquid types,
which are not recommended in this user manual
•
Bad or dirty gasoline, which results in
contamination of the fuel system
•
Use of unoriginal spare parts.
•
Other conditions where Texas cannot be held
responsible.
Whether a case is a warranty claim or not is
determined in each case by an authorized service
center.
Your receipt is your warranty note, why it should
always be kept safe.
REMEMBER: The purchase of spare parts as well as
any request for warranty repair, model number, year
and serial number should always been informed. It can
be found on the CE-label on the machine!
* We reserve the right to change the conditions and
accept no liability for any misprints
19