Storage; Recommended Hydraulic Oil; Maintenance - Texas A/S Power Split 700 H Bedienungsanleitung

Storage

Store the log splitter in a dry area.

Recommended hydraulic oil

We recommend the following oil for the hydraulic cylinder:
Texaco Rando HDZ32
Article number: 90306479
Or oil with corresponding viscosity.

Maintenance

Warning:
Before performing any maintenance, unplug the tool from the power source.
Changing the hydraulic oil
(Please see previous pages for recommended hydraulic oil.)
1. Make sure that the log pusher is fully withdrawn.
2. Unscrew the dip stick (A) and remove it com-
pletely together with the O-ring oil seal.
3. Place a container (B) under the log splitter that
can hold at least 4 Litre of oil. Afterwards tip the
machine in order to empty the oil into the con-
tainer.
4. Tip the log splitter the other way, with the oil
fill/drain port up (C). By using a clean funnel you
shall fill with a suitable quantity of fresh hydraulic
oil. Be sure to use only clean and high quality hy-
draulic oil specifically made for this purpose.
5. Clean the oil stick and insert it in the fuel tank in
order to make sure that the oil level is between
the two marks on the oil stick.
6. Clean the oil stick and O-ring thoroughly and re-
install. Be careful not to damage the threads of
the aluminium oil cover.
Refilling of hydraulic oil
• Please inspect the oil level periodically. The level must be in between the two markings
on the oil stick. If the oil level is too low, you shall refill by using a recommended oil.
www.texas.dk
16