Recommended Size Of Wood To Be Split - Texas A/S Power Split 700 H Bedienungsanleitung

5. Place the splitter safely. Please ensure that the splitter is placed firmly on a level
and supported surface in a height of 60-75 cm, free from any objects to prevent
movement of the operator. Never operate this splitter on the ground, as you will risk
it becoming damaged by bits and pieces, it is also uncomfortable to work in this po-
sition. It is recommended to use a permanent stand for the log splitter. If necessary
you can block the wheels with wedges in order to prevent them from moving.
6. Open the air escape valve. Loosen the air escape
valve by turning 3-4 times every time you use
the log splitter. Retighten this valve when you are
finished.
7. Where to place the log on the splitter.
Place the log onto the splitter, lengthwise and lying
flat on the main frame (I). The log shall lie flat on the
splitter and shall be placed onto the log guiding plates
(A). Never attempt to split the log at an angle.
Be sure that the wedge (J) and log pusher (B) touch
the log squarely on the ends.
8. Two hand operation.
When it is safe to start, press the engine start switch (F) with one hand. Wait a few
seconds while the engine starts up and creates a pressure in the hydraulic pump.
When it is safe to proceed you press the two handles (C) down with both hands.
The log pusher (B) will compress the log and push it against the wedge (J), which
splits the logs. When the logs have been split you shall release both handles, this
will allow the log pusher (B) to withdraw.
9. Warning: If the log does not split immediately, do not force it by maintaining the
thrust for more than a few seconds. This can damage the tool. It is better to try re-
positioning the log on the splitter or setting the log aside.
9. Stack as you are working. This will provide a safer working area, by keeping it un-
cluttered you avoid the danger of tripping or damaging the machine.
10. Remember to tighten the air escape valve when you have finished splitting.

Recommended size of wood to be split

The diameter of the log is only indicative. A small piece of wood can be difficult to split if it
has knots or if its fibres are very tough. A larger piece of wood can be split if its fibres are
smooth and loose.
Never force the log splitter to split more than 5 seconds with the cylinder under pressure
in order to split excessively hard wood. Overheated oil under pressure may damage the
machine. It is very important that if the log splitter does not split in the first attempt,
please stop the machine and rotate the log 90 degrees. If the wood still cannot be split,
it means that the hardness of the wood exceeds the capacity of the machine and it must
be rejected in order not to damage the log splitter.
Air escape valve
www.texas.dk
15