Parkside PFB 12 A1 Bedienungs- Und Sicherheitshinweise Seite 8

˜ Safe working practice
Maximum speed (n
The maximum rotational speed marked on the router bits must not be
exceeded .
Router bits with visible cracks must not be used (Fig . E) .
˜ Use
˜ Mounting and fastening of router
(Fig . C)
Disconnect the router from the mains before fitting the router
bits .
Tools and tool bodies should be clamped in such a way to ensure they
will not loosen during operation .
The router bits should be clamped all the way to the marked point on
the shank (Fig . C) .
Care shall be taken of router bits to ensure that the clamping is by the
shank of the tool and that the cutting edges are not in contact with each
other or with the clamping elements .
Fastening screws and nuts should be tightened using the appropriate
spanners, etc . provided by the manufacturer .
Extension of the spanner or tightening using hammer blows is not
permitted .
Clamping surfaces should be cleaned to remove dirt, grease, oil and
water .
Clamping screws must be tightened according to instructions .
8 GB/IE/NI
)
max