Regular Cuts; Plunge Cuts; Flush Cuts - Parkside Pasa 20-Li C2 Bedienungsanleitung Und Originalbetriebsanleitung

m CAUTION! Risk of injury and
damage to property!
Switch the product off immediately if the
u
saw blade jams . Try to spread the saw
cut and carefully pull the saw blade out .
Always stand to the side of the product
u
when working .
Always make sure that the workplace is
u
well ventilated .
Avoid over-stressing the product while
u
working .
˜ Regular cuts
1 . Verify the saw blade
workpiece .
2 . Switch the product on .
3 . Apply the base plate
4 . Use even pressure, advancing at a steady
pace when making the cut .
You can make horizontal, diagonal, or
vertical cuts (Fig . E) .
5 . When working with the grip bracket
move the product downwards while
applying light pressure (Fig . G) .
6 . When you are finished:
Switch the product off .
–
Pull the saw blade
–
workpiece .
˜ Plunge cuts
(Fig . F)
m CAUTION! Risk of kickback and
personal injury!
Only make plunge cuts in soft materials
u
(e .g . wood or plasterboard) using a short
saw blade (max . length: 150 mm) .
Plunge cuts are very challenging and are
u
associated with a higher risk of injuries .
Only use this technique if you are familiar
with it .
is not touching the
6 ] [
to the workpiece .
7 ] [
,
11 ] [
out of the
6 ] [
NOTE
Before making plunge cuts: Remove the
u
grip bracket .
[ 11 ]
1 . Place the front edge of the base plate
on the workpiece so that the saw blade
does not touch the workpiece .
2 . Switch the product on .
3 . Slowly plunge the saw blade
workpiece .
4 . When you have cut through the depth of
the workpiece, continue sawing as usual .
˜ Flush cuts
CAUTION! Risk of kickback and
m
personal injury!
Make sure that the saw blade
u
longer than the pipe diameter .
NOTE
Before making flush cuts: Remove the grip
u
bracket .
11 ] [
Using a flexible bi-metal saw blade you
u
can saw off protruding workpieces (e .g .
water pipes) flush to a wall .
1 . Place the saw blade
the wall .
2 . Bend the saw blade
pressure to the product so that the base
plate makes contact with the wall .
7 ] [
3 . Switch the product on .
4 . Saw off the workpiece by applying constant
pressure .
˜ Cleaning and care
m WARNING! Risk of injury!
Always switch the product off,
remove the battery pack
let the product cool down before
making any adjustments .
7 ] [
[ 6 ]
into the
6 ] [
is
6 ] [
directly against
6 ] [
by applying lateral
6 ] [
and
[ 3 ]
GB 17