Charging The Battery Pack; Attaching/Removing The Battery Pack; Checking The Battery Pack's Charging Level; Assembly - Parkside Pasa 20-Li C2 Bedienungsanleitung Und Originalbetriebsanleitung

˜ Charging the battery pack
m WARNING! Risk of injury!
Always unplug the charger
the mains before inserting/removing
the battery pack
NOTE
You can charge the battery pack
u
any time without reducing its life cycle .
Interrupting the charging process does
u
not damage the battery pack
Before operation: Charge the battery
o
pack when it is at medium or low
[ 3 ]
charging level (see "Checking the battery
pack charging level") .
The charging control LEDs (red
o
green ) indicate the status of the
14 ] [
charger and the battery pack
12 ] [
LED
Red LED lights up
[ 13 ]
Green LED lights
[ 14 ]
up
Green LED and
[ 14 ]
red LED flashing
13 ] [
Red LED flashing
13 ] [
Green LED lights
[ 14 ]
up (without battery
pack )
3 ] [
1 . Insert the battery pack
charger .
12 ] [
2 . Connect power plug of the charger
socket-outlet .
3 . When the battery pack
Disconnect the power plug of the
–
charger from the socket-outlet .
[ 12 ]
Remove the battery pack
–
charger .
[ 12 ]
from
[ 12 ]
.
3 ] [
at
[ 3 ]
.
[ 3 ]
and
13 ] [
.
3 ] [
Status
Battery pack
[ 3 ]
charges
Battery pack fully
3 ] [
charged
Battery pack
[ 3 ]
defective
Battery pack too
3 ] [
cold or too warm
Charger ready
[ 12 ]
into the
[ 3 ]
to a
12 ] [
is fully charged:
3 ] [
from the
[ 3 ]
˜ Attaching/removing the
battery pack
Attaching the battery pack
1 . Slide the battery pack
handle .
[ 2 ]
2 . Ensure the battery pack
noticeably in place .
Removing the battery pack
1 . Press the release button
pack .
[ 3 ]
2 . Pull the battery pack
handle .
2 ] [
˜ Checking the battery pack's
charging level
Press the button
o
LEDs light up .
16 ] [
Colour
Red/orange/green
Red/orange
Red
˜ Assembly
˜ Fitting/removing the grip
bracket
(Fig . C, D)
m WARNING! Risk of injury!
Always switch the product off,
remove the battery pack
let the product cool down before
making any adjustments .
Fitting the grip bracket
Push the grip bracket
o
the base plate
[ 7 ]
Removing the grip bracket
Press the release
10 ] [
o
bracket forwards out of the guides .
11 ] [
onto the
3 ] [
clicks
[ 3 ]
on the battery
[ 4 ]
from the
3 ] [
. The charging level
[ 15 ]
Charging level
Maximum
Medium
Low
and
[ 3 ]
over the guides on
[ 11 ]
and onto the product .
and pull the grip
GB 15