Handicare Combi SWL Gebrauchsanweisung Seite 6

Bedpan / Bucket rails:
The bed pan / bucket rails can be used in combination with a keyhole (fig.3) or round shaped bucket (fig.4).
To assemble - see figure 6:
The two end pieces (B, on the drawing) rest on the rear of the
seat frame.
For keyhole shape bucket, insert the two front rods (A) into the
inner holes (C).
For all other bucket shapes use the outer holes (D).
If no bucket or bed pan is being used, the rails may be
detached so the chair fits easily over a toilet.
Individual Adjustment -see figure 7
Attachment of castors & frame height adjustment:
The pin on the snaplock clip narrows in width from the front towards the end. The hole in the tubing is bigger on one side
and narrower on the other side. This safety feature means that the snaplock clip can only be inserted in one way into the
tubing, ensuring the castors to be mounted correctly.
Front castor: insert snaplock clip into tube hole from rear of tubing so pin points frontwards.
Rear castor: insert snaplock clip into tube hole from front of tubing so pin points backwards.
Height Adjustment:
By re-positioning the snaplocks on the chair legs, the Combi chair may be
adjusted to 6 different heights.
To adjust the height of the chair:
1. Remove snaplock.
2. Select one of the 6 positions.
3. Reinsert snaplock.
Repeat for all 4 legs.
6
Figure 3
IMPORTANT: Check that all four legs are the same height and that
all of the snaplocks are inserted correctly into the frame before use.
Figure 4
Fig 6
Fig 7
Figure 5